Pentax · SLR · M42

Pentax S1a (H1a)

35mm SLR Discontinued budget SLR · meterless · M42 screw mount · Honeywell export · hidden 1/1000 · fully mechanical

Twenty percent. That is roughly what camera-wiki says a buyer saved by taking the S1a instead of the SV, and Asahi found the money by leaving parts out rather than cheapening the ones it kept. Honeywell printed a single manual for the H3v and the H1a, and it lists just two differences between them: no self-timer, and a shutter dial marked only to 1/500. Everything else matches. If you never used the SV's self-timer, you were paying for something you did not want.

The second of those differences is mostly engraving. Past the 1/500 mark the dial keeps going to an unmarked 1/1000, and nothing on the top plate gives a hint of it. Asahi had the speed in the mechanism and simply chose not to print it on the cheaper body. Before you trust it on a camera this old, put it on a shutter tester. Cloth curtains that have sat in a drawer for decades can run slow or uneven at the narrowest slit, and that is exactly where an unmarked speed lives.

The lens mattered more than the dial. Unlike the earlier S1 with its semi-automatic glass, the S1a came with the Super-Takumar 55mm f/2 and a fully automatic diaphragm, so you focus at full aperture and the blades close only as the shutter fires. Bodies from 1964 onward were updated to take the new 50mm f/1.4 and carry an orange R on the rewind knob. Planning to mount that faster Takumar? Check for the orange letter before money changes hands.

There is no meter, and there never was one to fail. The shutter is a mechanical focal-plane unit running from a full second to 1/500 with T and B, and nothing in the body asks for a battery. Flash is the weak spot. X sync sits at about 1/50, which makes electronic fill in daylight awkward unless you load slow film and stop well down. Exposure is your job from the first frame, and a spot or incident reading from the Zone Light Meter app is the meter this body never had. Read the light once, set the dial, and read again when a cloud crosses the sun.

About 135,352 were made, and none were sold in Japan, where the Super S2 held the same rung. Outside the US it carried the Asahi Pentax S1a name; in America it wore Honeywell branding as the H1a, so search listings under both. People usually cross-shop it against the SV if they want the timer back, and against the Spotmatic if they want a meter behind the prism.

Take both of those away and you are left with a screw-mount Pentax, a fully automatic standard lens, and no electronics at all. The M42 thread opens up decades of Takumars and third-party glass. The camera itself will tell you nothing about the light you point it at. For someone learning exposure by hand, that silence is useful; anyone who wants a needle to follow should spend the extra on a Spotmatic.

How the app handles this body

  • Metering: Take an incident or spot reading in the app and place your shadows on a chosen zone, then dial that exposure in. On a body with no meter, or one whose cell has drifted with age, the app is the meter you trust.
  • Flash sync: Focal-plane shutter, so flash sync tops out around 1/50. Above that the app's exposure pairs still hold for available-light work.

Frequently asked questions

What film does the Pentax S1a (H1a) use?

The Pentax S1a (H1a) shoots 35mm film, with a 24x36mm frame.

Does the Pentax S1a (H1a) have a fixed lens or interchangeable mount?

It takes interchangeable M42 lenses.

What are the Pentax S1a (H1a)'s shutter speeds?

Its focal-plane shutter runs 1s to 1/500, with flash sync at 1/50.

Is the Pentax S1a (H1a) still made?

No, it is discontinued (1962-1968) and bought used.

More from Pentax

Lenses for the M42 mount

See every M42 lens

This article was drafted with AI from researched sources and checked against manuals and maker data. Nobody here has hands-on tested every item. How the articles are made. Spotted a mistake? Write to hello@zonelightmeter.com.

Related reading

← Back to the full camera list

Search documentation